Looptelecom

Loop-IP6800 Self-Healing Ring NTU

	Full front access (ETSI) unit
	Desk-top, wall or DIN Rail mounting
	Compact intelligent FX packet optical ring with layer-2 switch capability
	WAN port -Dual optical Fast Ethernet interfaces
	Tributary ports -3 ports 10/100 BaseT Ethernet (with PoE option)* -2 ports RS232/485 Interfaces, user selectable via 2-port DIP switch -2 Dry-Contact for input and 2 Dry Contact for output
	Power modules -Single fixed AC power supply -On-board fixed single/dual DC modules with dual feed
	Auto-discovery/topology, auto-diagnostic and remote-configure for easy plug-and-install (up to 64 units)*
	Up to 1024 MAC address
	High speed, full range asynchronous RS232/RS485 for point-to-point, point to multi-point, or Omni-bus-like applications
	Master/Slave units setting by using DIP switch*
	Auto-negotiating or forced for Speed
	Full/Half Duplex for tributary Ethernet ports*
	IEEE 802.3x flow control
	IEEE 802.1w RSTP
	Alarm Relay and ACO (Alarm Cutoff) button
	Alarm types: alarm cutoff, power failure, link up and link down on Ethernet, DTE and dry contact interfaces
	Remote firmware download via TFTP
	Remote configuration upload & download via TFTP
	Management port and interface -In-band management -RS232 console via DB9 connector -SNMP v1*, v2* -Telnet -LoopView GUI EMS*
	RoHS Compliance Product
	*Future Option

The Loop-IP6800 is a self-healing ring network termination unit (NTU) with a built-in L2 switch. It can be desk-top, wall or DIN Rail mounted. Ring protection or point-to-point protection is facilitated in 100 Base-FX. All end equipments can be either in packet format via Ethernet ports or serial data via RS232/485 interfaces which will be converted into packet format within Loop-IP6800. The Loop-IP6800 has two WAN optical interfaces, two RS232/485 DTE interfaces, three Ethernet LAN interfaces, two sets of dry contact IN/OUT interfaces, and one alarm relay connector. The Loop-IP6800 has a hardening option which will support –20�aC to 70�aC*. The Loop-IP6800 supports auto-discovery to discover all units on the ring, and also support remote-configure for the ease of installations.* The Loop-IP6800 supports single AC, single DC or dual DC to field requirement. The Loop-IP6800 facilitates automation systems, SCADA systems, surveillance systems, traffic control systems, transportation systems and IP networking with robust protection in ring, point-to-point, or Omni-bus-like topology. Easy installation and configuration also make maintenance or further expansion more efficient and cost-effective.